Home »» Placement Papers »» All Papers »» DRDO(CEPTAM) »» Placement Paper

DRDO Placement Paper Pattern Part - 1

Paper :  DRDO Placement   Paper Pattern Part - 1          
        Model for ECE:
     Direct Theory question:
     1. A triangular-square wave generator   uses
     * A sine wave oscillator and a   comparator
  * An integrator and a comparator
  * A diffrentiator and comparator
  * A sine wave oscillator and a clipper
     2. An amplifier has two identical   cascaded stages. Each stage has a BW of 20KHz. The overall BW shall be
     * 10KHz
  * 12.9KHz
  * 20KHz
  * 28.3HHz
     Direct numerical problem:
     1. 1. A parabolic dish antenna has a   diameter of 1m. the maximum possible ideal gain of the antenna at a wavelength   3.14cm is
     * 20 dB
  * 30 dB
  * 40 dB
  * 50 dB
     2. 2. The frequency deviation produced   in a VHF carrier by a signal of 100Hz is 50KHz. The frequency modulation is
     100 radians
  250 radians
  500 radians
  750 radians
     Application based theoretical or   numerical problem:
     1. Which one of the pulses has the same   form in time domain as well as in frequency domain
     2. Good voice reproduction via PCM   requires 128 quantization levels. If the BW of voice channel is 4KHz then data   rate is
     256 Kbps
  128 Kbps
  56 Kbps
  28 Kbps  

     3. Match the following:
     1. List 1 List2
  A. Thyristor 1. Second break down
  B. MOSFET 2. Large on-state drop
  C. IGBT 3. Small on state drop
  D. BJT 4. Slow device
     (a) A-4, B-3, C-2, D-1 (b) A-1, B-2,   C-3, D-4
  (c) A-4, B-2, C-3, D-1 (d) A-1, B-3,   C-2, D-4
     4. List 1 List2
  A. Free and forced response 1. Discrete   time systems
  B. Z transform 2. Dirichlet conditions
  C. Probability theory 3. Non-homogenous   differential equation
  d. Fourier series 4. Random process
        (a) A-1, B-3, C-2, D-4 (b) A-3, B-1,   C-2, D-4
  (c) A-1, B-3, C-4, D-2 (d) A-3, B-1,   C-4, D-2
     Assertion and reasoning type:
     The following item consists of two   statements labeled as Assertion A and the other as Reason R. Use the following   codes:
     (a) Both A&R are individually true   and R is the correct explanation of A
  (b) Both A & R are individually true   and R is not the correct explanation of A
  (c) A is true and R is false
  (d) A is false and R is true
     5. Every materials has a different value   of energy band gap except metals which have no band gap
     R The energy band gap is decided by the   equilibrium lattice constant, which is different in different materials.
  6. AOp-amp are commonly used in   instrumentation Op-amps do not load the circuit due to their very high input   impedance  


0 Answers